Did you try asyncmap 0 in your ppp options? On Tue, 23 Jun 1998, Sture Palminger wrote:
> > Hi Troy > > Thanks for your message. > Yes this is a pppd connection.I have played around with mtu and mru but ther > is > no bigger change. > Did your second suggestion and dialed upp the only BBS available around here. > The download speed was ~1.5 Kb/s ???? (run with minicom 115200 8N1 CTS/RTS). > The speed reported by BBS (CONNECT 115200) , my port settings are ttyS1 > UART:16550A,port:0x02f8, IRQ 3,baud_base:115200 and initialization string ATF > (factory configured). > Have to dig into this. > > Regards > Sture > > > > > On 19-Jun-98 Troy Hanson wrote: > >Is this with pppd connection? If so: Try using the utility setserial to > >set speed to spd_vhi (115200), also, setting the MTU and MRU to 576 helps a > >bit. (pppd options) > > > >If the progam is with direct serial (e.g. BBS, make sure you have the speed > >set to 115200 in the program). This could be a good test if your problem > >is with ppp connections. You can dial up to a BBS and try a Zmodem > >download, and see what kind of througput you get there (should be around > >3.5k/sec on 33.6k modem) > > > >Hope this helps! > >troy > > > > > -- > To UNSUBSCRIBE, email to [EMAIL PROTECTED] > with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED] > /*********************** Running Debian Linux *********************** * For God so loved the world that He gave his only begotten Son, * * that whoever believes in Him should not perish... John 3:16 * * W. Paul Mills * Topeka, Kansas, U.S.A. * * [EMAIL PROTECTED] * http://homepage.midusa.net/~wpmills/ * * [EMAIL PROTECTED] * http://www.networksplus.net/wpmills/ * * Bill, I was there several years ago, why would I want to go back? * ********************************************************************/ -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
