On Wed, 8 Apr 1998, dpk wrote: > I have an exabyte 8mm tape drive. I have compiled in scsi support, > and scsi tape drive support into the kernel. It shows up in dmesg: > > Vendor: EXABYTE Model: EXB-8200 Rev: 2618 > Type: Sequential-Access ANSI SCSI revision: 01 > > however, a device is not assigned to the drive. How do I tell which > device it is? I looked at the SCSI HOWTO and it didn't say much > about them except for that exabyte tape drives are supported. I also > tried a few of the defaults without success. > > Dennis
should be /dev/nst0 for non-rewinding access and /dev/st0 for rewinding --- Heute ist nicht alle Tage, ich komme wieder, keine Frage!!! Joerg -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
