Charles Read wrote:
> Earlier, I reported that: > > # cu --speed 115200 ---line /dev/ttyS1 > cu: open (/dev/ttyS1): Permission denied > cu: /dev/ttyS1: Line in use > > To fix this, I did: > > # vigr > [added my user name to the 'dialout' group] > # newgrp dialout > > Then: > > # cu --speed 115200 --line /dev/ttyS1 > Connected > [here I type "at&f", which is not echoed] > cu: write: I/O error > Disconnected > # > > I've tried using the minicom setup, but the dialout > there doesn't work either. Ditto for dip. > > Why doesn't my modem, once connected, accept > commands from keyboard input? > > Regards, > Charles > I know this may seem silly (especially since someone else commented that the cua devices are no longer used they are only there for compatibility reasons) buuuuuuut... Give a try using /dev/cua1 instead of /dev/ttyS1 and see what happens. I use /dev/cua1 at work on a dial-out box and have never had a problem with it. (I was almost certain that ttySx's were dial-in while cuax's were dial-out... hmmm.. weird. Of course, as it goes, either device you would think should perform the same task) -- TO UNSUBSCRIBE FROM THIS MAILING LIST: e-mail the word "unsubscribe" to [EMAIL PROTECTED] . Trouble? e-mail to [EMAIL PROTECTED] .
