I don't remember who (or even if it was someone in *this* list) who asked about this, but here's the info about 3com 3c503 jumper settings so you can rejumper your card for shared memory operation.
Actually, it looks like the info you need is printed on the board. There are two blocks of jumpers. One's a set of 8, and is used to set the IO base address, and should say 2e0,2a0,280,250,350,330,310,300 and the other set's the memory base address for shared memory and should be labeled disable,c8000,cc000,d8000,dc000 (five jumper positions). Just set the memory jumper to one of the available addresses (as long as it doesn't conflict with the shared mem for some other device), and off you go! -- Jens B. Jorgensen [EMAIL PROTECTED] -- TO UNSUBSCRIBE FROM THIS MAILING LIST: e-mail the word "unsubscribe" to [EMAIL PROTECTED] . Trouble? e-mail to [EMAIL PROTECTED] .
