Has anyone had any experience with an internal IDE Zip drive? My
parallel port model worked fine, but now that I've got the IDE version,
upon bootup I get a series of errors like the following:
hdc: recal_intr: status=0x51 { DriveReady SeekComplete Error }
hdc: recal_intr: error=0x20 { }
hdc: read_intr: status=0x59 { DriveReady SeekComplete DataRequest Error }
hdc: read_intr: error=0x20 { }
ide1: reset: success
hdc: recal_intr: status=0x53 { DriveReady SeekComplete Index Error }
hdc: recal_intr: error=0x20 { }
end_request: I/O error, dev 16:00, sector 0
unable to read partition table
VFS: Disk change detected on device 16:01
hdc:hdc: read_intr: status=0x59 { DriveReady SeekComplete DataRequest
Error }
ending with:
end_request: I/O error, dev 16:00, sector 0
unable to read partition table
hdc1: bad access: block=0, count=1
end_request: I/O error, dev 16:01, sector 0
HPFS: map_sector: read error
registered device ppp0
This is on a known good disk, formatted ext2fs. Any advice?
Thanks.
-bob
************************************
* Robert Kerr *
* [EMAIL PROTECTED] *
* http://www.et.byu.edu/~kerrr *
* Adam fell that men might be, *
* and men are that they might *
* have joy. 2 Nephi 2:25 *
************************************
--
TO UNSUBSCRIBE FROM THIS MAILING LIST: e-mail the word "unsubscribe" to
[EMAIL PROTECTED] .
Trouble? e-mail to [EMAIL PROTECTED] .
