[EMAIL PROTECTED] wrote: > > Hello everyone, > > I am getting "eth0:mismatched read page pointers 0 vs 1" when I ifconfig eth0 > "online" and this continues until I ifconfig eth0 down. These are continous > and repeated errors to console. I have an SMC 8416T at port 220 and interupt > 10 (both of these values are correctly autoprobed when I install the smc-ultra > module; in fact the internet address is also correctly reported). The system > is the base system only (base1-4) of Debian 1.2 (running kernel 2.0.27). > smc-ultra is v2.00. I am running on a 486DX50 (ISA bus). My network > connection in DOS is fully operational, reporting the same port # and irq. > DOS says the card is at address 0xC800. The net configuration was done "out > of the box" with the native Debian utilities on the "Rescue Disk." > > Where is the configuration hicupping? >
Maybe you've already checked this but... The Ethernet Howto says that this card must be "set" (jumper, software config???) to Ultra compatibility mode in order to work with the Ultra kernel driver. Here's the excerpt: 5.35.4. SMC EtherEZ (8416) Status -- Supported This card uses SMC's 83c795 chip and supports the Plug 'n Play specification. It also has an SMC Ultra compatible mode, which allows it to be used with the Linux Ultra driver. Be sure to set your card for this compatibility mode. See the above information for notes on the Ultra driver. For v1.2 kernels, the card had to be configured for shared memory operation. However v2.0 kernels can use the card in shared memory or programmed i/o mode. Shared memory mode will be slightly faster, and use considerably less CPU resources as well. Note that the EtherEZ specific checks were added to the SMC Ultra driver in 1.1.84, and hence earlier kernel versions will not detect or handle these cards correctly. -- Jens B. Jorgensen [EMAIL PROTECTED] -- TO UNSUBSCRIBE FROM THIS MAILING LIST: e-mail the word "unsubscribe" to [EMAIL PROTECTED] . Trouble? e-mail to [EMAIL PROTECTED] .
