Stephan Seitz wrote:
> No, but there maybe two things:
> 1) Do you have the chipset driver installed (compiled into the kernel
> or loaded as module)? Look at dmesg output, what your kernel says
> about your hardware.
>
> 2) You don't have a chipset supported by linux. Yes, this may happen.
By "chipset" do you mean the motherboard's IDE hardware?
> You could post the output of lspci and dmesg.
OK!
end of 'dmesg' output after running the hdparm commands again
hda: CHECK for good STATUS
hda: drive_cmd: status=0x51 { DriveReady SeekComplete Error }
hda: drive_cmd: error=0x04 { AbortedCommand }
ide: failed opcode was: 0xef
hda: drive_cmd: status=0x51 { DriveReady SeekComplete Error }
hda: drive_cmd: error=0x04 { AbortedCommand }
ide: failed opcode was: 0xef
hda: CHECK for good STATUS
hda: CHECK for good STATUS
hda: drive_cmd: status=0x51 { DriveReady SeekComplete Error }
hda: drive_cmd: error=0x04 { AbortedCommand }
ide: failed opcode was: 0xef
hda: drive_cmd: status=0x51 { DriveReady SeekComplete Error }
hda: drive_cmd: error=0x04 { AbortedCommand }
ide: failed opcode was: 0xef
hda: CHECK for good STATUS
partial output of 'lspci -v'
0000:00:1f.1 IDE interface: Intel Corp. 82801FB/FBM/FR/FW/FRW (ICH6 Family)
IDE Controller (rev 03) (prog-if 8a [Master SecP PriP])
Subsystem: Asustek Computer, Inc.: Unknown device 80a6
Flags: bus master, medium devsel, latency 0, IRQ 209
I/O ports at <unassigned>
I/O ports at <unassigned>
I/O ports at <unassigned>
I/O ports at <unassigned>
I/O ports at ffa0 [size=16]
0000:00:1f.2 IDE interface: Intel Corp. 82801FB/FW (ICH6/ICH6W) SATA
Controller (rev 03) (prog-if 8f [Master SecP SecO PriP PriO])
Subsystem: Asustek Computer, Inc.: Unknown device 2601
Flags: bus master, 66MHz, medium devsel, latency 0, IRQ 225
I/O ports at 8c00 [size=8]
I/O ports at 8880 [size=4]
I/O ports at 8800 [size=8]
I/O ports at 8480 [size=4]
I/O ports at 8400 [size=16]
Capabilities: [70] Power Management version 2
# lsmod |grep ide
ide_generic 1216 0 [permanent]
ide_disk 18016 0
ide_cd 41892 0
ide_core 130384 5 usb_storage,piix,ide_generic,ide_disk,ide_cd
cdrom 41216 1 ide_cd
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
