Hello Rob,
I have tried a kernel rebuild with this option (a snipit of my config is
below):
CONFIG_MPENTIUM4=y
CONFIG_HIGHMEM4G=y
CONFIG_MTRR=y
CONFIG_SMP=y
CONFIG_MTRR=y
CONFIG_SMP=y
But, I am still getting the same results.
-----------------
#~: uname -a
Linux blah 2.4.18 #3 SMP Thu Jun 2 10:08:29 CDT 2005 i686 unknown
#~: free
total used free shared buffers cached
Mem: 900264 149120 751144 0 5148 31336
-/+ buffers/cache: 112636 787628
Swap: 501832 0 501832
-----------------
I have also tried passing "MEM=1024M" to the boot parameters, but this
seems to do nothing as well.
-----------------
image=/boot/bzImage
label=Linux
read-only
append="MEM=1024M"
-----------------
Suggestions would be greatly appreciated.
--
~~~~~~~~~
-greg
"hrmmm - a Beowulf cluster of Dreamcasts and PS2s..."
-Slashdot.org post
On Thu, Jun 02, 2005 at 09:18:50AM -0600, Rob Sims wrote:
> On Wed, Jun 01, 2005 at 04:38:39PM -0500, Greg Gilmour wrote:
> > I currently have an HP Proliant DL360 G3 with two 2.8 GHz Xeon
> > processors, SmartArray 5i, and 1024 MB of memory installed currently. I
> > wanted to install more memory so I purchased and installed 2 GB more to
> > make a grand total of 3 GB of system memory (PC2100 DDR ECC) -- 2x512 MB
> > sticks and 2x1024 MB sticks.
>
> > Upon boot-up the BIOS detects all 3 GB, but once I boot into Linux it
> > only registers as 900264 KB. I've tried checking the BIOS on the server
>
> You need a kernel with high memory support. In the kernel configuration,
> it is:
> Processor type and features
> High Memory Support (4G)
>
> --
> Rob
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
