On Monday 30 May 2005 17:38, Muhammad Ali wrote: Hello Muhammad.
Here are the steps I take to setup a dialup connection. If the box as a ethernet card installed you will need to set up the system for a static ip address for that ethernet card. The ethernet card static ip needs no gateway ip and no dns ip addresses. If you miss this setup on the install of Sarge just install apt-get install etherconf and configure. If you need to run etherconf again use the command as su dpkg-reconfigure etherconf Here is a link to help setup Debian for dialup. http://newbiedoc.sourceforge.net/peripherals/modem.html All so have a look that the link below. Its about the mtu size for dailup and dsl connection. The link is directed towards microsoft users, but he mtu faxs are there. By having a correct mtu size you will be able to get that little bit more out of the connection. http://www.dslreports.com/faq/3701 To change the dialups mtu edit /etc/ppp/options and replace #mtu <n> with mtu 576 > Note: forwarded message attached. > > __________________________________________________ > Do You Yahoo!? > Tired of spam? Yahoo! Mail has the best spam protection around > http://mail.yahoo.com -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
