On Sat, May 07, 2005 at 04:06:43PM -0400, Thomas H. George wrote: > I have on the hard drive 20 wav files (Signed 16 Bit Little Endian, Rate > 44100 Hz, Stereo).
> ln -s filename.wav trackxx where xx runs from 01 to 20 > > and then burning the cd with the command > > cdrecord -v dev="ATA:1,1,0" -pad -audio trackxx A file with a name like track01 must contain raw data: "...MSB left, LSB left, MSB right, LSB right, MSB left and so on. The track should be a multiple of 2352 bytes. "If a filename ends in .au or .wav the file is considered to be a structured audio data file." > The result was 20 tracks of noise although CD Player knew the name of > the tape and the titles of songs (The 20 files were captured from tape > using Jackd and Ardour and I assume CD Player obtained this information > from the Internet as my system was online). Yes, you had header junk and the rest of the data were byte-swapped. Use track01.wav instead for your links. And I assume your cdrecord line ended with track?? instead of trackxx. Replace this with track??.wav. I have not seen an audio player that won't handle track at once recording; however, if that's the issue, look into the -dao and -sao options, or use cdrdao. You can also try a lower recording speed. The ideal speed may vary with media. Unless a disc from a very specific list (per drive) of known media is used, the laser strategy is not optimized, resulting in a poor quality recording. -- Rob -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
