At 02:27 AM 9/29/2004, you wrote:
On Tuesday 28 September 2004 18:00, Luis Fernando Llana D�az wrote:
> Hi all,
> I have de following flash card reader, does anybody know how to make
> it works?
>
> 0000:00:10.1 FLASH memory: ENE Technology Inc CB710 Memory Card Reader
> Controller
> Subsystem: Asustek Computer, Inc.: Unknown device 1724
> Control: I/O+ Mem- BusMaster- SpecCycle- MemWINV- VGASnoop-
> ParErr- Stepping- SERR- FastB2B- Status: Cap+ 66MHz- UDF-
> FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort-
> >SERR- <PERR- Interrupt: pin B routed to IRQ 19 Region 0: I/O
> ports at 8800 Capabilities: [a0] Power Management version 2
> Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA
> PME(D0+,D1+,D2+,D3hot+,D3cold-) Status: D0 PME-Enable-
> DSel=0 DScale=0 PME-
Does /dev/sda (or /dev/sdb or something like that, if you have other USB
drive-like devices) appear when you plug the card reader in? (In my
experience you may have to wait a few minutes for the device to be
created.)
On my laptop, which is a Toshiba Satellite A35, my cardbus controller is from
ENE Technology. Some memory card readers are connected to the cardbus,
not by usb. It may help to read this article:
http://tuxmobil.org/Mobile-Guide/mobile-guide-p2c2s1-card-reader.html
HTH,
Jamie
pgps8F2Xiy2wy.pgp
Description: PGP signature
