eth0 Link encap:Ethernet HWaddr 00:50:FC:XX:XX:XX
inet addr:203.109.xxx.xx Bcast:203.109.xxx.xx Mask:255.255.255.xxx
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:4109 errors:0 dropped:0 overruns:0 frame:0
TX packets:1079 errors:8 dropped:0 overruns:0 carrier:16
collisions:23 txqueuelen:100
RX bytes:809755 (790.7 KiB) TX bytes:169903 (165.9 KiB)
Interrupt:16 Base address:0xa000
When i check the link with mii-tool i get the following response:
box:/etc# mii-tool -v eth0 eth0: 10 Mbit, half duplex, no link product info: vendor 00:00:00, model 0 rev 0 basic mode: 10 Mbit, half duplex basic status: no link capabilities: advertising:
NO LINK? But im connected to the thing - and its connected to a 100Mbit hub... Is this a problem with the ethernet card?
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
