On Wednesday 22 September 2004 14:50, Josh Lauricha wrote:
> I have the following:
> ABIT KD7A
> Athlon XP 2800+
> Western Digital 180GB (WD1800BB)
> Generic 16x DVD-ROM
>
> And am getting:
> hda: dma_timer_expiry: dma status == 0x21
> hda: DMA interrupt recovery
> hda: DMA timeout error
> hda: DMA timeout error: status=0xd0 { Busy }
>
> hda: DMA disabled
> ide0: reset: success
> hda: lost interrupt
> hda: task_out_intr: status=0x59 { DriveReady SeekComplete DataRequest
> Error }
> hda: task_out_intr: error=0x00 { }
>
> hda: DMA disabled
> hda: drive not ready for command
> ide0 reset: success
>
> Regularly. The drive will reset (with an audible click), then do a
> little more and timeout again. I'm trying to install Sarge running
> 2.6.8, but the same problem happens with 2.4.26. I've tried booting
> with noacpi, nodma, ide=nodma and noapic with no success. I've tried
> different combos of connecting the drives, both on primary, dvd on
> secondary, etc. I've disabled DMA in the BIOS, but it still seems to
> try to use it. I've reset the BIOS. Is there anything else I can try?
> Anyone else running one of these boards? Based on the dmesg output, it
> doesn't seem like the noapic arg does anything on this board.
>
> Please CC, I'm not subscribed.
>
>
Are you sure the drive is good? I had problems like this, and smartmontools
showed the drive was failing. I replaced it, and haven't had any problems
since.
Justin Guerin
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
