Thanks... I did modconf and when I do lsmod, I can now see it. It shows as follows:
Module Size Used by eepro100 14888 0 (unused) How do I now check to see if it is the correct driver, and how do I go about configuring it... (giving it an ip address)? Why does it say (unused)? Thanks... > On Monday 21 June 2004 07:44 am, [EMAIL PROTECTED] wrote: >> Just installed debian 3.0... I'm using an Intel Pro/100 VM NIC. It >> did not install for some reason during install. The following came >> from a Windows log file: >> >> Driver: e100bnt.sys >> Driver Ver: 3.37.07.0000 >> >> I should be able to use modprobe to load driver right? What driver do >> I use? How can I find a list of available drivers? >> >> ifconfig does not show eth0 >> >> Thanks... > > > The file '/etc/network/interfaces' manages your network, (man > interfaces). Use 'modconf' to pick the module for your nic card, > modconf adds the modules to a list of modules to be loaded at boot time > so you don't have to load each time. > -- > Greg Madden > > > -- > To UNSUBSCRIBE, email to [EMAIL PROTECTED] > with a subject of "unsubscribe". Trouble? Contact > [EMAIL PROTECTED] > -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
