OK, fixed that problem, but, with "sarge", I still get the following errors (same as original problem):
modprobe: failed to load module floppy eval: 3: Syntax error: newline unexpected (expected ")") With "woody", it can't find my network hardware (Intel 82547EI Gigabit LAN controller). Any help with either of these would be greatly appreciated. Regards, Allen > -----Original Message----- > From: Kent West [mailto:[EMAIL PROTECTED] > Sent: Sunday, June 20, 2004 3:48 PM > To: [EMAIL PROTECTED] > Subject: Re: "sarge" install: "Install base system" bombs and disk > errors (?) > > > Allen Williams wrote: > > >This is a brand new system- no data to worry about, but would like to get > >the system installed. Given a brand new system, don't think my > hardware is > >dying, but, of course, anything is possible. > > > > > > > >>-----Original Message----- > >>From: J.H.M. Dassen (Ray) [mailto:[EMAIL PROTECTED] > >>Sent: Sunday, June 20, 2004 1:04 PM > >>To: [EMAIL PROTECTED] > >>Subject: Re: "sarge" install: "Install base system" bombs and disk > >>errors (?) > >> > >> > >>On Sun, Jun 20, 2004 at 11:08:59 -0400, Allen Williams wrote: > >> > >> > >>>and, on console alt-F4, I am getting these error messages: > >>> > >>>June 20 00:58:56 (none) syslog.warn klogd: hdc: media error > >>> > >>> > >>(bad sector): > >> > >> > >>>status=0x51 { DriveReady SeekComplete Error } > >>> > >>> > >>>Is there anyplace that tells me how to decode these error messages? > >>> > >>> > >>The usual decoding is "your disk is dying, hope you have a good > backup. If > >>not, try to backup any data you want to keep NOW." > >> > >> > /dev/hdc is usually (but not always) the CD-ROM drive. This is > indicative of a bad/scratched/dirty CD, or a faulty CD-ROM drive, or a > bad CD-ROM cable/controller. I'd start by trying a different install CD > (or a different CD-ROM drive if you have one available). > > -- > Kent > > > -- > To UNSUBSCRIBE, email to [EMAIL PROTECTED] > with a subject of "unsubscribe". Trouble? Contact > [EMAIL PROTECTED] -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
