On Wed, Jun 16, 2004 at 09:58:22AM -0600, Marvin Gerardo Aguero Salazar wrote:
> OK. The make install displayed a line like
>
> #!/sbin/depmod -a
>
> I thought it had done. Anyway, I did so and as far as modules and
> modprobe it seem to be working.
Good!
> As far as my card being recognized, it is not.
Not so good.
> I even rebooted the machine and dmesg displays the following two lines:
>
> ndiswrapper version 0.8-rc2 loaded
> ndiswrapper adding bcmw15.sys
This looks ok, at least the driver is being loaded.
> I think it should be working by now. Anyway, back to the HOWTO again.
What does `iwconfig' tell you? Before `modprobe ndiswrapper' I have:
[EMAIL PROTECTED]:dfokkema$ sudo iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
After modprobing ndiswrapper, I have
[EMAIL PROTECTED]:dfokkema$ sudo iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
wlan0 IEEE 802.11b ESSID:""
Mode:Managed Frequency:2.462GHz Access Point: FF:FF:FF:FF:FF:FF
Bit Rate:11Mb/s Tx-Power:16 dBm
RTS thr:2347 B Fragment thr:2346 B
Encryption key:off
Power Management:off
Link Quality:100/100 Signal level:-10 dBm Noise level:-256 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
What is your output?
> Thanks again David.
You're welcome!
> BTW, what does HTH stand for?
Hope This Helps!
David
--
Hi! I'm a .signature virus. Copy me into
your ~/.signature to help me spread!
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
