On Tue, May 18, 2004 at 06:43:51PM -0400, Emily Dryden wrote: > I purchased a new Linksys Wireless Router, BEFW11S4 to replace an > earlier model which was damaged by a lightning caused power surge. The > ethernet connections to the router work perfectly but the web based > setup program to configure the wireless connections wont download. The > instructions say enter http://192.168.1.1 in the browser but when I do > so it either times out or say connecton refused. I used this address to > configure the old router with no difficulty.
I used the same model for a year or so, until I tripped over its power cord, yanked it off its shelf to the floor, and destroyed it. Make sure your machine's current IP address is on the same subnet as 192.168.1.1. You may have to use ipconfig to temporarily/permanently change your eth0 config. -- Carl Fink [EMAIL PROTECTED] Manager, Dueling Modems Computer Forum <http://dm.net> -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
