Sandip, Do you have ipchains or iptables enabled? What output do you get if you do iptables -L ?
What is the exact message when you try to ping? Do you get an error? Does it hang? Does it time out? Do you know if the network card is workign and doesn't have a physical problem? Regards. On Sat, Oct 05, 2002 at 11:28:56AM +0530, Sandip P Deshmukh wrote: > hello all. > > i have a networking problem and despite some efforts i put in, it > remains unresolved. > > setup: > my computer runs debian 3.0. it is connected to a lan. and through the > lan to the net. i have a static ip address. the server runs win nt. > several other computers running different win flavours are connected to > the server. > > objective: > access the internet from my computer. > access other computers on lan > access hp printers connected other computers (640c, 710c, r45, etc) > > status: > i am unable to ping my machine's ip address, server's ip address. > > ifconfig: > -------- > eth0 Link encap:Ethernet HWaddr 00:50:BA:3C:C0:93 > inet addr:192.168.1.21 Bcast:192.168.1.255 Mask:255.255.255.0 > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 > RX packets:4 errors:0 dropped:0 overruns:0 frame:0 > TX packets:21 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:100 > RX bytes:252 (252.0 b) TX bytes:2486 (2.4 KiB) > Interrupt:11 Base address:0xa000 > > lo Link encap:Local Loopback > inet addr:127.0.0.1 Mask:255.0.0.0 > UP LOOPBACK RUNNING MTU:16436 Metric:1 > RX packets:8 errors:0 dropped:0 overruns:0 frame:0 > TX packets:8 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:0 > RX bytes:560 (560.0 b) TX bytes:560 (560.0 b) > > > interfaces > ---------- > # /etc/network/interfaces -- configuration file for ifup(8), ifdown(8) > > # The loopback interface > auto lo > iface lo inet loopback > > # The first network card - this entry was created during the Debian > installation > # (network, broadcast and gateway are optional) > auto eth0 > iface eth0 inet static > address 192.168.1.21 > netmask 255.255.255.0 > network 192.168.1.0 > broadcast 192.168.1.255 > gateway 192.168.1.22 > > > dmesg - after running stop and start networking manually > -------------------------------------------------------- > eth0: Setting 100mbps full-duplex based on auto-negotiated partner > ability 45e1. > > eager to shift to linux but unable to till i overcome this difficulty. > > thanx in advance, > > sandip > -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
