On Mon, Sep 16, 2002 at 06:44:07PM -0700, Michael Olds wrote: > Requesting Help Setting-up CDRW > --------------- > I had this same hardware setup running under RH7.3 > > Intel 845 P4 1.6G; 768MbRAM > Debian: 2.4.18-bf2.4
This is the kernel version, not the debian. Debian is 3.0, I suppose. > the SCSI emulation module was installed during the initial setup, and > lsmod returned: ide-scsi used 0 (Does the "used 0" mean anything?) It means, the module ide-scsi is currently not needed. > Question: > /dev/cdrom /cdrom iso9660 ro,user,noauto 0 0 > remains in /etc/fstab. Is this correct? Do you have an extra cd-rom? Then this is correct. > --------------- > When I run cdrecord I get the following message: > "Unable ... could this be the IDE device where you in fact use > ide-scsi so that sr0 or sda or so is needed?" What did you give cdrecord as dev= argument? It needs to be the (pseudo)scsi-device with bus,target,lun e.g. dev=0,0,0 > When I run cdrecord -scanbus I get: > No such file or directory. > (Thinking that this might be something like setting up a new partition, I > set up a > directory under / named "cdrw" > but that did not solve the problem. Did you really load all necessary modules? Can you post the ide- and scsi-section of your /boot/config-2.4.18? Are the appropriate entries in /dev present? Especially /dev/sg*? The output looks like missing /dev entries. Christoph -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
