El miércoles, 25 feb 2015, a las 23:29 UTC+1 horas, Fabián Bonetti escribió:
>On Wed, 25 Feb 2015 14:06:15 -0300 >Felix Perez <felix.listadeb...@gmail.com> wrote: > >El resultado del disco duro > >smartctl 5.41 2011-06-09 r3365 [i686-linux-3.2.0-4-686-pae] (local build) >Copyright (C) 2002-11 by Bruce Allen, http://smartmontools.sourceforge.net > >=== START OF INFORMATION SECTION === >Device Model: Hitachi HDS721616PLA320 >Serial Number: PVF904ZFTALALN >LU WWN Device Id: 5 000cca 33ae0ff92 >Firmware Version: P22OABGA >User Capacity: 160,041,885,696 bytes [160 GB] >Sector Size: 512 bytes logical/physical >Device is: Not in smartctl database [for details use: -P showall] >ATA Version is: 7 >ATA Standard is: ATA/ATAPI-7 T13 1532D revision 1 >Local Time is: Wed Feb 25 19:26:38 2015 ART >SMART support is: Available - device has SMART capability. >SMART support is: Enabled > >=== START OF READ SMART DATA SECTION === >SMART overall-health self-assessment test result: PASSED > >General SMART Values: >Offline data collection status: (0x00) Offline data collection activity > was never started. > Auto Offline Data Collection: Disabled. >Self-test execution status: ( 241) Self-test routine in progress... > 10% of test remaining. >Total time to complete Offline >data collection: ( 2865) seconds. >Offline data collection >capabilities: (0x5b) SMART execute Offline immediate. > Auto Offline data collection on/off > support. > Suspend Offline collection upon new > command. > Offline surface scan supported. > Self-test supported. > No Conveyance Self-test supported. > Selective Self-test supported. >SMART capabilities: (0x0003) Saves SMART data before entering > power-saving mode. > Supports SMART auto save timer. >Error logging capability: (0x01) Error logging supported. > General Purpose Logging supported. >Short self-test routine >recommended polling time: ( 1) minutes. >Extended self-test routine >recommended polling time: ( 48) minutes. >SCT capabilities: (0x003f) SCT Status supported. > SCT Error Recovery Control supported. > SCT Feature Control supported. > SCT Data Table supported. > >SMART Attributes Data Structure revision number: 16 >Vendor Specific SMART Attributes with Thresholds: >ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED >WHEN_FAILED RAW_VALUE > 1 Raw_Read_Error_Rate 0x000b 086 086 016 Pre-fail Always > - 4194387 > 2 Throughput_Performance 0x0005 100 100 050 Pre-fail Offline > - 0 > 3 Spin_Up_Time 0x0007 125 125 024 Pre-fail Always > - 160 (Average 160) > 4 Start_Stop_Count 0x0012 099 099 000 Old_age Always > - 4794 > 5 Reallocated_Sector_Ct 0x0033 100 100 005 Pre-fail Always > - 21 > 7 Seek_Error_Rate 0x000b 100 100 067 Pre-fail Always > - 0 > 8 Seek_Time_Performance 0x0005 100 100 020 Pre-fail Offline > - 0 > 9 Power_On_Hours 0x0012 094 094 000 Old_age Always > - 45309 > 10 Spin_Retry_Count 0x0013 100 100 060 Pre-fail Always > - 0 > 12 Power_Cycle_Count 0x0032 099 099 000 Old_age Always > - 4790 >192 Power-Off_Retract_Count 0x0032 095 095 000 Old_age Always >- 6533 >193 Load_Cycle_Count 0x0012 095 095 000 Old_age Always >- 6533 >194 Temperature_Celsius 0x0002 157 157 000 Old_age Always >- 38 (Min/Max 9/52) >196 Reallocated_Event_Count 0x0032 100 100 000 Old_age Always >- 21 >197 Current_Pending_Sector 0x0022 100 100 000 Old_age Always >- 0 >198 Offline_Uncorrectable 0x0008 100 100 000 Old_age Offline >- 0 >199 UDMA_CRC_Error_Count 0x000a 200 253 000 Old_age Always >- 135 > >SMART Error Log Version: 1 >Warning: ATA error count 25 inconsistent with error log pointer 3 > >ATA Error Count: 25 (device log contains only the most recent five errors) > CR = Command Register [HEX] > FR = Features Register [HEX] > SC = Sector Count Register [HEX] > SN = Sector Number Register [HEX] > CL = Cylinder Low Register [HEX] > CH = Cylinder High Register [HEX] > DH = Device/Head Register [HEX] > DC = Device Command Register [HEX] > ER = Error register [HEX] > ST = Status register [HEX] >Powered_Up_Time is measured from power on, and printed as >DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes, >SS=sec, and sss=millisec. It "wraps" after 49.710 days. > >Error 25 occurred at disk power-on lifetime: 45287 hours (1886 days + 23 hours) > When the command that caused the error occurred, the device was active or > idle. > > After command completion occurred, registers were: > ER ST SC SN CL CH DH > -- -- -- -- -- -- -- > 84 51 01 01 00 00 00 Error: ICRC, ABRT at LBA = 0x00000001 = 1 > > Commands leading to the command that caused the error were: > CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name > -- -- -- -- -- -- -- -- ---------------- -------------------- > 61 08 00 20 a4 ba 41 ff 04:18:15.100 WRITE FPDMA QUEUED > 61 08 b8 d8 8a 48 40 08 04:18:15.100 WRITE FPDMA QUEUED > 61 10 b0 80 8a 48 40 08 04:18:15.100 WRITE FPDMA QUEUED > 61 08 a8 88 52 cc 40 08 04:18:15.100 WRITE FPDMA QUEUED > 61 08 a0 18 a4 ba 40 08 04:18:15.100 WRITE FPDMA QUEUED > >Error 24 occurred at disk power-on lifetime: 45285 hours (1886 days + 21 hours) > When the command that caused the error occurred, the device was active or > idle. > > After command completion occurred, registers were: > ER ST SC SN CL CH DH > -- -- -- -- -- -- -- > 84 51 01 01 00 00 00 Error: ICRC, ABRT at LBA = 0x00000001 = 1 > > Commands leading to the command that caused the error were: > CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name > -- -- -- -- -- -- -- -- ---------------- -------------------- > 61 80 30 f0 72 81 44 ff 02:44:11.000 WRITE FPDMA QUEUED > 61 80 68 a0 70 81 40 08 02:44:10.200 WRITE FPDMA QUEUED > 61 00 60 a0 6c 81 40 08 02:44:10.000 WRITE FPDMA QUEUED > 61 a0 58 90 35 84 40 08 02:44:09.400 WRITE FPDMA QUEUED > 61 00 50 90 31 84 40 08 02:44:09.400 WRITE FPDMA QUEUED > >Error 23 occurred at disk power-on lifetime: 45285 hours (1886 days + 21 hours) > When the command that caused the error occurred, the device was active or > idle. > > After command completion occurred, registers were: > ER ST SC SN CL CH DH > -- -- -- -- -- -- -- > 84 51 01 01 00 00 00 Error: ICRC, ABRT at LBA = 0x00000001 = 1 > > Commands leading to the command that caused the error were: > CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name > -- -- -- -- -- -- -- -- ---------------- -------------------- > 61 e0 c0 f9 c6 82 44 ff 02:43:54.600 WRITE FPDMA QUEUED > 61 e0 78 00 d9 82 40 08 02:43:54.600 WRITE FPDMA QUEUED > 61 60 70 98 d8 82 40 08 02:43:54.600 WRITE FPDMA QUEUED > 61 e0 68 f8 cf 82 40 08 02:43:54.600 WRITE FPDMA QUEUED > 61 00 60 f8 cb 82 40 08 02:43:54.600 WRITE FPDMA QUEUED > >Error 22 occurred at disk power-on lifetime: 45189 hours (1882 days + 21 hours) > When the command that caused the error occurred, the device was active or > idle. > > After command completion occurred, registers were: > ER ST SC SN CL CH DH > -- -- -- -- -- -- -- > 84 51 01 01 00 00 00 Error: ICRC, ABRT at LBA = 0x00000001 = 1 > > Commands leading to the command that caused the error were: > CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name > -- -- -- -- -- -- -- -- ---------------- -------------------- > 61 08 00 a0 3f b8 41 ff 1d+18:46:29.100 WRITE FPDMA QUEUED > 61 08 20 08 3a be 40 08 1d+18:46:29.100 WRITE FPDMA QUEUED > 61 08 18 88 88 bd 40 08 1d+18:46:29.100 WRITE FPDMA QUEUED > 61 10 10 80 8a 1e 40 08 1d+18:46:29.100 WRITE FPDMA QUEUED > 61 08 08 90 45 1e 40 08 1d+18:46:29.100 WRITE FPDMA QUEUED > >Error 21 occurred at disk power-on lifetime: 45176 hours (1882 days + 8 hours) > When the command that caused the error occurred, the device was active or > idle. > > After command completion occurred, registers were: > ER ST SC SN CL CH DH > -- -- -- -- -- -- -- > 84 51 01 01 00 00 00 Error: ICRC, ABRT at LBA = 0x00000001 = 1 > > Commands leading to the command that caused the error were: > CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name > -- -- -- -- -- -- -- -- ---------------- -------------------- > 61 20 00 60 05 c9 41 ff 1d+06:01:42.700 WRITE FPDMA QUEUED > 61 20 d0 48 ab db 40 08 1d+06:01:42.700 WRITE FPDMA QUEUED > 61 20 c8 40 05 c9 40 08 1d+06:01:42.700 WRITE FPDMA QUEUED > 61 20 c0 b0 53 9e 40 08 1d+06:01:42.700 WRITE FPDMA QUEUED > 61 20 b8 90 45 9e 40 08 1d+06:01:42.700 WRITE FPDMA QUEUED > >SMART Self-test log structure revision number 1 >Num Test_Description Status Remaining LifeTime(hours) >LBA_of_first_error ># 1 Short offline Completed without error 00% 44549 - ># 2 Extended offline Interrupted (host reset) 90% 44548 - ># 3 Short offline Completed without error 00% 44548 - ># 4 Short offline Completed without error 00% 39672 - ># 5 Short offline Completed without error 00% 19768 - ># 6 Extended offline Aborted by host 60% 10947 - ># 7 Short offline Completed without error 00% 10896 - ># 8 Short offline Completed without error 00% 10838 - ># 9 Short offline Completed without error 00% 10838 - >#10 Short offline Completed without error 00% 10838 - >#11 Short offline Completed without error 00% 10838 - > >SMART Selective self-test log data structure revision number 1 > SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS > 1 0 0 Not_testing > 2 0 0 Not_testing > 3 0 0 Not_testing > 4 0 0 Not_testing > 5 0 0 Not_testing >Selective self-test flags (0x0): > After scanning selected spans, do NOT read-scan remainder of disk. >If Selective self-test is pending on power-up, resume after 0 minute delay. > > > >Segun entiendo es usable. Pues no sé qué decirte. Si entiendo bien la tabla, tu disco tiene capacidad para realojar 5 sectores defectuosos, y la cuenta va ya por 21. Tiene también 25 errores contados, mantiene el registro de los últimos 5, y estos se suceden en horas o días. Saludos. -- Manolo Díaz -- To UNSUBSCRIBE, email to debian-user-spanish-requ...@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org Archive: https://lists.debian.org/20150226000211.4b91d...@gmail.com
