-------- Original Message --------
Subject: Re: Fucken Gate's Modem
Date: Sun, 07 May 2006 22:01:13 +0400
From: aeos93 <[EMAIL PROTECTED]>
To: Dmitry Nezhevenko <[EMAIL PROTECTED]>
References: <[EMAIL PROTECTED]>
<[EMAIL PROTECTED]> <[EMAIL PROTECTED]>
<[EMAIL PROTECTED]> <[EMAIL PROTECTED]>
<[EMAIL PROTECTED]> <[EMAIL PROTECTED]>
<[EMAIL PROTECTED]>
<[EMAIL PROTECTED]> <[EMAIL PROTECTED]>
Dmitry Nezhevenko wrote:
On Sun, May 07, 2006 at 07:19:22PM +0400, Maksim A. Boyko wrote:
можно и без него, например попробуй позвонить echo "atd5555555" >
/dev/ttyS0. Я так и не понял модули для модема уже скомпилены или мы
пытаемся оживить модем без мозгов?
Тогда уже echo "ATD555555\r\n". Был случай, что винмодем не хотел звонить
без \r\n. На то он и винмодем.
echo - ничего не происходит
хотел показать:
/sbin/lspci
0000:02:02.0 Communication controller: Conexant HSF 56k HSFi Modem (rev 01)
[EMAIL PROTECTED]:/home/azod# ls -l /dev/modem
lrwxrwxrwx 1 root root 10 2006-05-07 12:43 /dev/modem -> /dev/ttyS0
[EMAIL PROTECTED]:/home/azod#
так же после инсталяции появилась папка “Modem” в домашней директории,
содержащая три текстовика:
DriverCompiling.txt
ModemData.txt
Testing.txt
Log самой инсталляции не нашёл, искал в /var/log
Пока буду изучать Linux-kernel HOWTO...
Я не совсем понял, что, слепо следовать командам, данным ниже и т.д.?
Посмотрите и скажите мне
Я к ядру никогда не прикасался
Вот фрагмент из DriverCompiling.txt:
COMPILING DRIVERS, for Linux Newbies
This text provides a very minimal introduction to compiling drivers,
particularly WinModem drivers under Linux. All points are covered in
much more detail in the Linux Kernel-HOWTO which is likely included
in the documentation set, installed within /usr/share/doc/ folders.
All that follows can be summarised in a few steps/actions:
Install a kernel_source package representing your kernel.
As it will match only one of several kernels that could have been
installed
and NOT necessarily yours, clean out any remnants of earlier usages with:
make mrproper
Copy in your kernel configuration file and have if read with:
make oldconfig
Edit if necessary the fourth line of the Makefile, which completes
specification of where drivers will be installed to.
FileName.h encoding dependencies between cogent code parts will next
be assembelled by:
make dep
which for the 2.6.n kernel releases is instead automatically included in:
make bzImage
With kernel_source thus Correctly configured, the modem driver
compilation and installation
proceeds within its own resource package,with the included README
providing these details;
quite commonly there are only commands:
make clean
make DriverName
make install
which will compile the drivers and install them properly.
The remainder of this text just expands on these issues and steps.
и далее далее далее
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
