> > hub.c: new USB device 00:1f.2-2, assigned address 3 > > usb.c: USB device 3 (vend/prod 0xea0/0x2168) is not claimed by any > > active driver > > . > > Initializing USB Mass Storage driver... > > usb.c: registered new driver usb-storage > > scsi1 : SCSI emulation for USB Mass Storage devices > > Vendor: JetFlash Model: TS512MJF2B Rev: 2.00 > > Type: Direct-Access ANSI SCSI revision: 02 > > WARNING: USB Mass Storage data integrity not assured > > USB Mass Storage device found at 3 > > USB Mass Storage support registered. > > Attached scsi removable disk sda at scsi1, channel 0, id 0, lun 0 > > sda: Unit Not Ready, sense: > > Current 00:00: sense key Unit Attention > > Additional sense indicates Not ready to ready change,medium may have > > changed SCSI device sda: 1024000 512-byte hdwr sectors (524 MB) > > sda: Write Protect is off > > /dev/scsi/host1/bus0/target0/lun0: p1 p2 p3 p4 > > usb_control/bulk_msg: timeout > > usb_control/bulk_msg: timeout > > usb_control/bulk_msg: timeout > > usb_control/bulk_msg: timeout > > usb_control/bulk_msg: timeout > > usb_control/bulk_msg: timeout > > usb_control/bulk_msg: timeout > > usb_control/bulk_msg: timeout > > usb-storage: host_reset() requested but not implemented > > scsi: device set offline - command error recover failed: host 1 > > channel 0 id 0 lun 0 SCSI disk error : host 1 channel 0 id 0 lun 0 > > return code = 6050000 I/O error: dev 08:01, sector 0 > > FAT: unable to read boot sector > > Похоже, что дело в заиможействии usb и scsi. Как собрано ядро? В каком > порядке загружаются модули? ядро Дебиановское 2.4.24, 2.4.26, 2.6.8 один хфиг
> Можно попробовать вкомпилить намертво и scsi, scsi-disk и usb, > usb-storage.
