I wasn't sure if I should send this here, or file a bug report, or what? I thought I'd start here. I am currently booting to testing / wheezy, and had previously installed the driver for 64bit from sourceforge: http://sourceforge.net/projects/cupsdriverkodak/ but it stopped working.
I discovered there was a package in synaptic for sid for this printer and I temporarily enabled the sid repo to install the newer version of cups (1.5) and the 18-4 version of the c2esp package. I also did a 'make uninstall' for the previously installed driver. However with this new one it still won't print. It works in squeeze just fine, 64bit (via dual-boot, and I have an old laptop running 32bit squeeze, it prints fine with both of them.) The initial error log when attempting to do a test print shows: W [22/Aug/2011:10:04:52 -0700] failed to CreateProfile: org.freedesktop.DBus.Error.ServiceUnknown:The name org.freedesktop.ColorManager was not provided by any .service files W [22/Aug/2011:10:04:52 -0700] failed to CreateDevice: org.freedesktop.DBus.Error.ServiceUnknown:The name org.freedesktop.ColorManager was not provided by any .service files E [22/Aug/2011:10:04:52 -0700] KODAK_ESP_5200_Series_AiO: File "/usr/lib/cups/filter/c2esp" not available: No such file or directory I then found a message on the related sourceforge site for an error about the filter and it suggested setting the log level to debug, which I've done and I have output that I can send or upload some place if needed. I installed the printer in a browser using the localhost:631 address, and in the area to select printer file or browse for a ppd it actually shows the option 'Kodak ESP 5200 (en)' listed twice. I installed the printer using the first one, then deleted it and installed using the 2nd one and had the same result both times. Also I looked under /usr/share/ppd and there are no ppd's for this printer after I did the 'make uninstall'. The only place I found a ppd was under /etc/cups/ppd so I then modified the printer and pointed to that file and it still wouldn't print. It's connected via usb, if that matters. And my firewall was not enabled. I'm tempted to just remove cups and the driver files and reboot and start fresh with the source driver file again, but I thought I'd try this route first, in case it might affect others too. In the meantime if I need to print something while I'm booted to wheezy I'll just use my laptop for the print server. -- To UNSUBSCRIBE, email to [email protected] with a subject of "unsubscribe". Trouble? Contact [email protected] Archive: http://lists.debian.org/[email protected]
