Greetings, I have just updated my good old Pegasos II, running Debian/PPC in 24/7 since 2007 to Wheezy, from the weird mix of Lenny and Squeeze it had earlier. I have ran into two major issues with this new version.
- the mv643xx_eth doesn't work, in a weird way. The link detection works, link comes up on both ends of the cable, also it shows up in the kernel log. If I start tcpdump on the interface I can see broadcasted packets from other boxes on the network coming in, but I can't transmit anything. Not even the link on the switch blinks when I'm trying to transmit. So incoming traffic seems to work, outgoing doesn't. I tried to use ethtool to set the device to lower speeds or half-duplex mode, but doesn't work either. The device was working perfectly with some 2.6.25 kernel I was previously using and I didn't change the hardware setup. - hardware 3D was previously working on this box, but not any more. Even if I have Direct rendering: Yes in glxinfo, it still says MESA Software Renderer in use. XOrg.0.log says r200 doesn't provide the necessary exports, so AIGLX is disabled. Yes, I have installed package firmware-linux (also non-free). The config is: Pegasos II/G4 Rev 2B3, 1GB RAM, OF 20051216 (latest), Radeon 9250 128MB. My boot command is simply vmlinuz root=/dev/sda1 I'm using the default kernel config as provided by Debian. Any ideas? I can send logs, dumps, whatever needed. I can even give account to someone on the machine who's willing to investigate or test at least the network issue. Thanks, -- Karoly Balogh (Charlie) -- To UNSUBSCRIBE, email to debian-powerpc-requ...@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org Archive: http://lists.debian.org/alpine.deb.2.02.1307111224170.10...@scenergy.dfmk.hu
