Hi Holger,
So I got over the problem with quik and debian is installed here are some
notes.
When choosing the to be installed version I get the following message:
wget -q http://debian.uni-essen.de/debian//dists/sarge/Realease _O - | grep
^Suite: | cut -d' ' -f 2
which would seem to suggest sarge is being installed? After choosing stable,
the text moves away too quickly and I wasn't able to find any other relevant
messages in the install log.
http://penguinppc.org/bootloaders/quik/quirks.php says:
Requires special: output-device /bandit/ATY,264GT-B
load-base may need to be changed to 100000.
Correct. I also had to run:
nvsetenv boot-device ata/[EMAIL PROTECTED]:2
and then mount /proc did the trick, thank you very much.
chroot /target
mount /proc
quik -v
Success!
I'm also always up for testing the ~wouter floppies if there are any
changes made there.
Cool!
please drop me an email if you make any changes.
I installed the base system and booted into the 2.4 kernel. The problem is
whenever I try to open a bigger file the screen freezes and the system
crashes. After reboot there's no note in /var/log/messages as to what
happened. Also happens with vi or when I try to startx. I upgraded to the
2.6.8 kernel and the same thing happened. I then did a dist-upgrade to etch
and... still the same problem. However now the system only freezes when I
startx and not if I only open a file. I had debian with bootx on the same
machine before and this didn't happen. The only difference I can think of is
that I now have an ext2 partition instead of ext3.
On the bright side the dist-upgrade was successful. Unfortunately when I
installed the new kernel, 2.6.18, I got a kernel panic.
VFS: cannot open root device "hda2"
please append correct "root=" boot option
kernel panic - not syncing VFS: unable to mount root fs on unknown-block
(0,0)
Is this some udev, hotplug problem? I can still boot into the 2.6.8 kernel.
Getting back into the installed system now that I turned off the computer
is beyond me. Using the miboot floppies let's me boot and open a terminal,
but I don't see /target or anything else I could mount.
I did manage to use the floppies to get into my installed system. However I
had to follow all the install steps up to and including partitioning. After
repartition, with hda2, where everything is installed, staying a ext2
partition so the partition isn't erased, I found /target in the file system
again and could access it. This seems a little unpractical. Isn't there a
better way to get back at the installed filesystem via the floppies?
Another thing, a couple of people have posted in the last little while about
installing debian on old world macs. Would it be possible to put a link to
the debian sarge powerpc installation manual on the same page where you have
the miboot floppies since this might answer most questions.
Anyhoo, thanks for the help so far, Rob Homsi
_________________________________________________________________
Express yourself instantly with MSN Messenger! Download today it's FREE!
http://messenger.msn.click-url.com/go/onm00200471ave/direct/01/
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
