At Sat, 25 Mar 2006 17:01:05 -0800 (PST), humera tan wrote:
>
> hi
> I have a question about my computer
> My moniter says "Out of scan range" and its not working.
> Do you have any ideas how to fix it?
> If you have any ideas let me know.
You most probably need to explicitly write down the Hsync/VSync ranges
in your xorg.conf file.
For example, something like this:
Section "Monitor"
Identifier "LCD Display"
HorizSync 25-80
VertRefresh 56-75
EndSection
You need to look up the correct values for horizontal sync and
vertical refresh rate of your monitor.
In addition, you may need to generate specific ModeLines for the
graphical modes you wish to use. You can do this with 'gtf'. You
just need to add the output of this program in your xorg.conf.
So you would end up with something like this:
Section "Monitor"
Identifier "LCD Display"
HorizSync 25-80
VertRefresh 56-75
# 1280x1024 @ 70.00 Hz (GTF) hsync: 74.62 kHz; pclk:
128.94 MHz
Modeline "1280x1024_70.00" 128.94 1280 1368 1504 1728
1024 1025 1028 1066 -HSync +Vsync
EndSection
Then, in the Screen section, you need to add this mode. For example
like this:
Section "Screen"
...
SubSection "Display"
Depth 24
Modes "1280x1024_70.00"
EndSubSection
EndSection
Good luck,
Ruben
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
