Hans Ekbrand wrote:
On Mon, Dec 05, 2005 at 04:53:39PM +0100, Frédéric Massot wrote:
[...]
My problem is to boot directly under Linux, I configured quik, modified
Open Firmware with :
- boot-device scsi/[EMAIL PROTECTED]:2
- boot-file /boot/vmlinux root=/dev/sda2
- load-base 4000
And load-base 60000, 100000 and then 1000000
At the boot the system stops with this message :
DEFAULT CATCH!, code=FFF00700 at %SRR0: FF862AB4 %SRR1: 00081070
Is this an error from OF, or from the linux kernel? (Looks like an OF
error)
Is load-base 4000 the default setting? Otherwise, reset to the default
setting and try again (my Performa 5400 boots nicely with quik and I
only need to set the boot-device parameter).
For Quik, I use a first.b-g3, the configuration of Quik is :
root=/dev/sda2
timeout=20
image=/boot/vmlinux
label=Linux
read-only
When, I run quik -v, I have :
# quik -v
Second-stage loader is on /dev/sda2
Conffile is /etc/quik.conf
Config file is on partition 2
Writing first-stage QUIK boot block to /dev/sda2
Making /dev/sda2 bootable (map entry 2)
Writing block table to boot block on /dev/sda2
It is OK ?
When I use BootX for booting to Linux, I have in Open Firmware :
- boot-device /AAPL,ROM
- boot-file
- load-base 600000
Which are the parameters which you have in Open Firmware ?
If I change the parameter boot-device to "scsi/[EMAIL PROTECTED]:2", I always have
the error message : DEFAULT CATCH!, code=...
I found this documentation on this error message :
http://www.netbsd.org/Ports/macppc/faq.html#default-catch
I reboot the G3 several times without success. :o(
The version of the Open Firmware is 2.0f1
Thank you to help me.
Regards.
--
==============================================
| FREDERIC MASSOT |
| http://www.juliana-multimedia.com |
| mailto:[EMAIL PROTECTED] |
===========================Debian=GNU/Linux===
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
