Hello Michael, Michael Schmitz <[EMAIL PROTECTED]> wrote: >> >> Where is it? And for what is this sensor? >> > >> > The 'where' is answered by a printk in the module. And it isn't there >> > because it doesn't control a fan. >> >> Does "GPU ON DIE" control a fan? And why ommit this information, only > > Look at your OF device tree, it lists both the sensors and the fan > locations.
I can't interpret what that means: #v+ $ cat /proc/device-tree/[EMAIL PROTECTED]/[EMAIL PROTECTED]/[EMAIL PROTECTED]/hwsensor-location PWR/MEMORY BOTTOMSIDECPU BOTTOMSIDEGPU ON DIECPU COREREAR MAIN ENCLOSURE #v- The sensor is located at bottom side? >> why it has no fan? How else can I get this information? > > By adding some code to the thermostat module (the current code explicity > skips sensor #0. precisely because there's no fan present that could be > used to directly influence the respective temperature. The sensors are > read primarily as input into the fan control algorithm. Printing them to > sysfs is just an added benefit). > > That's what I did to read out the adt7640 'local temperature' sensor - I > found the output not very helpful, and disabled that code again. Was this so much code, that is would take an extra effort to maintain it? Regards, Jörg. -- > Ich kenn mich mit OpenBSD kaum aus, was sind denn da so die > Vorteile gegenueber Linux und iptables? Der Fuchsschwanzeffekt ist größer. :-> Message-ID: <[EMAIL PROTECTED]> -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
