On 9 May, this message from [EMAIL PROTECTED] echoed through cyberspace: >> > Tried your suggestion i.e. ATM zero L zero (ATM0L0) >> > instead of ohs-no change, still much garbage going to the >> > logs.Perhaps this works but i'm not adding it at the right place >> > for the init script. I've added it to ATM in /etc/diald/connect and >> > /etc/chatscripts/provider. > >> Perhaps you should read the logs and see what it thinks it's sending >> to the modem as the command string? I would hope it prints that out.> > > This is an sample of the log : > > Delaying 30 seconds before clear to dial. > May 8 23:30:00 ibian diald[197]: Trigger: udp 192.168.0.1/1790 > 198.235.216.135/53 > May 8 23:30:00 ibian diald[197]: Calling site 64.228.184.241 > May 8 23:30:02 ibian chat[5115]: abort on (BUSY) [snip] > May 8 23:30:02 ibian chat[5115]: abort on (DELAYED) > May 8 23:30:02 ibian chat[5115]: send (ATZM0L0^M) > May 8 23:30:02 ibian chat[5115]: expect (OK) > May 8 23:30:03 ibian chat[5115]: ATZM0L0^M^M > May 8 23:30:03 ibian chat[5115]: OK
Hmmm... ATZ is a modem reset. Perhaps the following two commands (ATM0L0) are not taken into account? Try and put those on a separate line in your chat script, i.e. duplicate the ATZ line plus the following line, and replace the second ATZ with ATM0L0. Hope this helps... Cheers Michel ------------------------------------------------------------------------- Michel Lanners | " Read Philosophy. Study Art. 23, Rue Paul Henkes | Ask Questions. Make Mistakes. L-1710 Luxembourg | email [EMAIL PROTECTED] | http://www.cpu.lu/~mlan | Learn Always. "
