Hi
I have a PowerMac G4 (Gigabit ethernet) 450Mhz dual processor. It has
been working fine on the LAN using the standard 2.4.18 kernel.
Currently I'm still dual booting (MacOSX) using Yaboot 1.3.8.
I recompiled the kernel for SMP support and after a couple of tries the
new kernel compiled and installed successfully. However, I seem to
have lost network connectivity - I can't ping the Router which is also
the DHCP server. I haven't found a way to post the output from dmesg
to the Mac side so that I could attach it but I believe the relevant
entries are as follows:
eth0 PHY ID 0x00206047
<snip>
(last four lines of dmesg below)
eth0 Found Broadcom BCM5400 PHY Gigabit
eth0 Link state change, phy_status: 0x616d
eth0 Link up ! BCM54xx aux_stat: 0xf534 (link mode: 5)
eth0 Full Duplex: 1, Speed: 100
The above would suggest that ethernet is working fine. I went back to
menuconfig to check that I hadn't missed a vital networking ingredient
and compiled again but no improvement resulted.
As I've now recompiled twice, I seem to have lost the original kernel
configuration to get back to where I was before - so I'm a bit stuck ;-(
Any suggestions or comments would be appreciated.
Thanks
Clive
____________________________
Clive Menzies & Associates Limited
strategies for business
http://www.clivemenzies.co.uk
75 Priory Road, London N8 8LR
d/l: 020 8348 0996
fax: 087 0705 2066
