On 16 July 2002 18:14 "Philipp Kaeser" <[EMAIL PROTECTED]> wrote
} I do not know if the PB 3400 uses the same hardware, but it is } to be suspected; so you might possibly profit from my configuration } files. I have put them online at } http://www.gubbe.ch/linux/pb2400-pcmcia.php (pcmcia config) } and at } http://www.gubbe.ch/linux/dev-globalvillage.php (for modem stuff) In http://www.gubbe.ch/linux/pb2400-pcmcia.php you say "modify /etc/pcmcia.conf". I don't have a pcmcia.conf file. Should I create one and add the values you recommend? Well, I managed to screw up both my woody and my potato installation last night. On woody, getty kept spawning every five minutes, so I commented out every occurence of getty in the rc.init file. Doh! I mis-read tty[1-6] for ttys[1-6], so I thought I was commented out something to the (pseudo-)? serial ports. And I don't have a console to attach. For potato, I try to do a minimal install... I don't select anything from tasksel until after I reboot. Then I run tasksel -s. But the system keeps freezing when it comes to TeX stuff. Last night, it was on "***purging old tex files***". Previously, it had been installation of some tetex docs. I'll just leave this one at the scratching-head stage. I also discovered another reason why I don't like using potato with my computer. I get hundreds of "unresolved symbols" regarding pcmcia. I get off of work early today, so I'll fiddle around and try to get a functioning woody again. Regarding memory allocation, would it hurt if I included both 0x80000000-0x80ffffff and 0x90000000-0x90ffffff ranges in my config.opts? Oh, and I figured out what /dev/ttyS00 was. It is, in fact, a serial port. just not my internal modem or my pcmcia modem. It's the modem/printer port. Tune in tomorrow... same deb time, same deb channel. --Aaron -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
