I have finally been able to install Debian 2.2r5 on my PowerMac 5500 with 15" Apple MultiScan Monitor. I ran xviddetect which detected Mach 64 as the vidoe card. But i haven't been able to start up X.
When i give the command startx, the monitor goes dark for some seconds and then gives error message similar to the one in the thread below: http://groups.google.com/groups?hl=en&lr=&ie=UTF8&oe=UTF8&threadm=a05001900b642ffbf62cc%40%5B129.49.78.115%5D&rnum=1&prev=/groups%3Fq%3Dstarting%2Bx%2Bfbdev%2Bmach64%2Bmultiscan%2Bgroup:comp.os.linux.powerpc%26hl%3Den%26lr%3D%26ie%3DUTF8%26oe%3DUTF8%26selm%3Da05001900b642ffbf62cc%2540%255B129.49.78.115%255D%26rnum%3D1 In fact my problem is quite similar to Croshow in the thread. I tried the remedy in the reply but it has no effect. I ran anXious to configure the X but do startx after that, the error message says that there is no compatible driver available or something like that; when i check the /etc/X11/XF86Config the screen section has "accl" as the driver. When i change it to "fbdev", it goes back to the former error message. Any suggestion would be much appreciated. thx Asif ________________________________________________________ Outgrown your current e-mail service? Get a 25MB Inbox, POP3 Access, No Ads and No Taglines with LYCOS MAIL PLUS. http://login.mail.lycos.com/brandPage.shtml?pageId=plus -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
