B&W G3 Installed Kernel Hangs after loading ohci_hid

[dotsony]

I've been trying to install sarge on a B&W G3 with a rev c logic board, 
adaptec scsi card, and an ide drive on which I'm installing testing. 
I've been at this off and on for a week or two, and I always get stuck 
at the same point. The installer works well enough, but for some reason 
none of the installed 2.6 kernels will finish booting. It loads SCSI, 
prints out a lot of output about pcilyx then it prints out the first 
two lines of ohci_hid's output, and then just hangs there says somthing 
about "64 blocks ". The installer kernel of the same release works 
fine. The USB keyboard works throughout the installation process. I 
have no idea what's going on, I can't look at any logs or anything.

I tried to install a 2.4.27 kernel, but it dies because it can't read 
my hard drive position (no such device (0,0)) so i'm assuming that's 
because the ide driver isn't built into the 2.4.27 image.

I've tried downloading a fresh kernel after booting the installer and 
chrooting into the install. I tried the appending nousb option, but the 
kernel came up in recovery mode on account of having to reset it after 
the crash, and without the usb modules the keyboard didn't work. I 
couldn't do anything to the machine so I just hard reset it again. So 
how can the installer

Kernel work so well and the same kernel installed on a hard drive work 
so badly? I've searched around the internet and I haven't seen anyone 
with the same problem. I've got

--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]