On Tuesday, January 24, 2006 11:01 AM, Rakotomandimby Mihamina
<[EMAIL PROTECTED]> wrote:
> On Sun, 2006-01-22 at 18:59 +0100, Christoph Haas wrote:
>> To get working dpatches I recommend using the 'dpatch-edit-patch'
>> command.
[...]
> I had a look at the man page, but I did not see how to go on or edit
> an already existing dpatch.
[...]
> Then when compile, I see that I made a typo.
> I dont wana re-edit the whole code I modified.
> How should I do?
The man page is quite clear, imho.
dpatch-edit-patch(1):
When dpatchname exists, dpatch-edit-patch will set up a working
source tree, apply all dpatches listed in
debian/patches/00list
up to and including dpatchname, and spawn an interactive
shell
for the developer. The developer then edits files in this
work-
ing tree. When the developer is done, they exit the
shell.
dpatch-edit-patch then updates dpatchname to reflect the
changes
made. Should the developer wish to abort the process from
the
interactive shell, they need only cause the shell to exit
with
an exit value of 230. Typically, this is done by exiting
the
shell with the command exit 230.
So just run "dpatch-edit-patch foo" again.
Regards,
Adam
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
