On Fri, Mar 14, 2008 at 22:51:01 +1030, squareyes wrote: > Matt Tretin wrote: >> I have the same computer, with the same problem. Booting with acpi=off >> will work -- but not the best solution on a laptop. I've tried >> every kernel configuration this way to sunday with no avail. >> >> - Matt >> >> On Thu, 2008-03-13 at 14:28 +1030, squareyes wrote: >> >>> Hi all, >>> CD/DVD drive will install system, but not there after install on >>> Lenovo 3000 N200. >> >> > Hi, > I have been told of a possible solution quote below > > "When I was setting up my toshiba satellite I came across this > http://gentoo-wiki.com/HARDWARE_Toshiba_Satellite_P100#Linux_Support > gentoo articel. > there it says the optical drive needs some kernel command parameter (in this > case: combined_mode=libata) to work properly." > > Have had 3 suggestions as to where pass this parameter > > /etc/modprobe.d/options > > /boot/grub/menu.lst and look for "defoptions" > /etc/sysctl.conf > > None of the above work, Any suggestions welcome.
Are you using Etch? Maybe you need a newer kernel than the default 2.6.18. You can get newer kernels suitable for installation on Etch from www.backports.org or you could try one of Kenshi Muto's updated Debian installer images (http://kmuto.jp/debian/d-i/). -- Regards, | http://users.icfo.es/Florian.Kulzer Florian | -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]