Joris wrote:
[4294991.502000] ACPI: PCI Interrupt 0000:03:00.0[A] -> Link [LNKA] ->
GSI 11 (level, low) -> IRQ 11
[4294991.503000] eth1: uploading firmware...
[4294991.586000] eth1: firmware version: 1.0.4.3
[4294991.586000] eth1: firmware upload complete
[4294991.756000] eth1: resetting device...
[4294991.756000] eth1: uploading firmware...
[4294991.841000] eth1: firmware version: 1.0.4.3
[4294991.841000] eth1: firmware upload complete
[4294992.841000] eth1: no 'reset complete' IRQ seen - retrying
[4294993.841000] eth1: no 'reset complete' IRQ seen - retrying
[4294993.841000] eth1: interface reset failure
[4294993.841000] prism54: Your card/socket may be faulty, or IRQ line
too busy :(
try adding pci=noacpi to your kernel command line.
if you are using grub, edit /boot/grub/menu.lst at the line starting
with '# kopt='. run 'sudo update-grub' afterwards to propagate it to the
actual kernel parameters.
good luck,
One more information ... I set ESSID, and wep key with
System->Administration->Networking
menu. But when I check with iwconfig command it say nothing set for
these ...
eth1 Link encap:Ethernet HWaddr 00:30:B4:00:00:00
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Interrupt:11
Thats all information when I can give for u :)
THX
t
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
