I'm a Debian newbie, trying to check it out after two years on RH. I am trying to install on my laptop, a Clevo D400. On the first boot after installation, I am getting hung just before starting the X server
"I cannot start your X server...it is likely that it is not set up correctly..." I installed from CDs burnt from the ISOs for 30r. The rest of the installation (Vanilla) seemed to go OK, and Mandrake and RH9 ran on this laptop previously. There is a full page of report from which I am advised to determine the error, but nothing specific is identified here. The line listed as "error" (EE) plus the line above is (--) Assigning device section with no busID to primary device (EE) No devices detected. Fatal server error: no screens found I'd appreciate any help. Chuck --------------------------- Charles Muller <[EMAIL PROTECTED]> Faculty of Humanities, Toyo Gakuen University http://www.acmuller.net
