Hi
Anybody knows which module should I use to set up
"Broadcom NetXtreme Fast Ethernet".
It´s from a IBM ThinkPad R40e, and knoppix tell me
that is not supported, hopefully they are not right...
I´ve got a kernel 2.4.18 (source) y una image-deb of a
2.4.21
I tried with some of the modules ( tg3 as well) but
nothing.
Thank you
Ivan Garcia.
PS: sorry about my English
I´ve attached fragment of dmesg y lspci -vv
PCI: Found IRQ 11 for device 00:03.0
Redundant entry in serial pci_table. Please send the
output of
lspci -vv, this message (10b9,5457,1014,0535)
and the manufacturer and name of serial board or modem
board
to [EMAIL PROTECTED]
register_serial(): autoconfig failed
RAMDISK driver initialized: 16 RAM disks of 4096K size
1024 blocksize
Initializing Cryptographic API
00:0b.0 Ethernet controller: BROADCOM Corporation:
Unknown device 170d (rev 01)
Subsystem: IBM: Unknown device 0545
Control: I/O- Mem+ BusMaster+ SpecCycle-
MemWINV- VGASnoop- ParErr- Stepping- SERR+ FastB2B-
Status: Cap+ 66Mhz+ UDF- FastB2B+ ParErr-
DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 64 (16000ns min), cache line size 08
Interrupt: pin A routed to IRQ 11
Region 0: Memory at e8000000 (64-bit,
non-prefetchable) [size=64K]
Expansion ROM at <unassigned> [disabled]
[size=64K]
Capabilities: [48] Power Management version 2
Flags: PMEClk- DSI- D1- D2-
AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=1
PME-
Capabilities: [50] Vital Product Data
Capabilities: [58] Message Signalled
Interrupts: 64bit+ Queue=0/3 Enable-
Address: f9fd1c3ced7dfff8 Data: ff
___________________________________________________
Yahoo! Messenger - Nueva versión GRATIS
Super Webcam, voz, caritas animadas, y más...
http://messenger.yahoo.es
