Hi Ben, On Fri, May 02, 2003 at 10:02:03AM +1000, ben wrote: > stage 2.. > > I have dri working now (sort of?) and drm installed. > being a bit of a noob at x (& linux in general) I just copied my modeline > section from 1400x1050 and duplicated it for all resolutions. >
that's not too good without modifying it and adapt it to the new
resolution.
> now when I run Tuxracer I just get a blue screen, with sound.
> no actual graphics.
>
> the modelines Read along the lines of:
>
> # 800x600 @ 60Hz, 65.8 kHz hsync
> Modeline "800x600" 129 1400 1464 1656 1960
> 1050 1051 1054 1100 +HSync +VSync
That's the point. The Modeline specifies the pixel-points of the end of
screen, sync begin and end and so on. You have to recalculate the
Modelines in this way:
800x600
Modeline "800x600" 129 800 864 1056 1360
600 601 604 650 +HSync +VSync
I don't think, that this will work out of the Box, but you should
understand for what the Modelines actually were specified. However, I
cannot switch between different resolutions interactively, too, but I
tried kxconfig, a module for the kontrolcenter (I assume using KDE),
which gave me reasonable Modelines.
HTH,
jochen
> however I really don't know what all that means..
> I'ld better do some more reading, could I maybe have my refresh rates wonky?
>
> Cheers,
>
> Ben.
>
>
> Joao Pedro Clemente wrote:
> >Oh, and I'm suposing you have kernel support for DRM, etc... Please check
> >that too..
> >
> >
>
>
> --
> To UNSUBSCRIBE, email to [EMAIL PROTECTED]
> with a subject of "unsubscribe". Trouble? Contact
> [EMAIL PROTECTED]
>
--
----------------------------------------
jochen issing
mailto:[EMAIL PROTECTED]
http://www.mcf-music.de
GPG:0A121BC8
----------------------------------------
pgpoKahqKF43u.pgp
Description: PGP signature
