I have similar errors on my laptop using the Belkin card. I posted a similar request for information when I started using the card, and got no responses. I haven't found it to be a performance problem, so I just ignore the entries. Let me know if you find out anything more interesting.
Best, Andy Perrin ---------------------------------------------------------------------- Andrew J Perrin - http://www.unc.edu/~aperrin Assistant Professor of Sociology, U of North Carolina, Chapel Hill [EMAIL PROTECTED] * andrew_perrin (at) unc.edu On Tue, 29 Apr 2003, Thomas Nyman wrote: > Hi, > > As some of you may have noted I had some problems with my Belkin card. > However I finally got it going..averything seems ok although perhaps a bit > sluggish at times. > > In my syslog I have the following errors > ----------------- > kernel: eth1: Tx error, status 1 (FID=01F1) > kernel: eth1: Tx error, status 1 (FID=017C) > kernel: eth1: Tx error, status 1 (FID=0551) > kernel: eth1: Tx error, status 1 (FID=049B) > kernel: eth1: Tx Error -110 writing packet header to BAP > kernel: eth1: Tx error, status 1 (FID=03C8) > kernel: eth1: Unknown Rx error (0x3). Frame dropped > kernel: eth1: Unknown Rx error (0x3). Frame dropped > kernel: eth1: Undecryptable frame on Rx. Frame dropped > ------ > > Does anyone have any idea what is causing this? The last message I guess is > an encryption problem although i dont seem to understand why. > > In my AP's firmware I have noted that when setting encryption keys (64 or > 128) you have to define four keys. One key is the default key. There is > also an option called "Open systen", and one "Shared" > > I have discovered that if I enable 64 bit encryption and enable Shared then > my card cannot communicate with the AP. However if my card has encryption > set and the AP has Open enabled it works - with errors generated above. If > i turn off encryption in my pc-card then it cannot communicate with the AP. > > Anyway, I would be very glad if anyone had an idea as to the problem here. > > Thomas > > > -- > To UNSUBSCRIBE, email to [EMAIL PROTECTED] > with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED] > >
