On Thu, Sep 12, 2002 at 08:48:19PM -0400, [EMAIL PROTECTED] wrote:
| You also need to edit /etc/pcmcia/wireless.opts for the ESSID, type of
| network, and WEP key.
|
| In addition you need to edit /etc/pcmcia/network.opts to specify DHCP or
| static configuration.
The Netgear FA511 is a Cardbus 10/100 card for a wired network. It's
not a wireless adapter and so the SSID settings, WEP key, etc. don't
apply for this card.
I have the FA511 working well in a Toshiba Portege 7200 series. It
uses the tulip_cb module. IIRC, I had to set
PC Card Controller Mode = CardBus/16-bit
in my Toshiba BIOS before it would function properly.
tau:~# dmesg
<snip>
Linux PCMCIA Card Services 3.1.33
kernel build: 2.4.18 unknown
options: [pci] [cardbus] [apm]
Intel ISA/PCI/CardBus PCIC probe:
PCI: Enabling device 00:0b.0 (0000 -> 0002)
PCI: Found IRQ 11 for device 00:0b.0
PCI: Enabling device 00:0b.1 (0000 -> 0002)
PCI: Found IRQ 11 for device 00:0b.1
Toshiba ToPIC95-B rev 07 PCI-to-CardBus at slot 00:0b, mem 0x10000000
host opts [0]: [slot 0xd0] [ccr 0x11] [cdr 0x86] [rcr 0xc000000] [pci irq
11] [lat 64/176] [bus 20/20]
host opts [1]: [slot 0xd0] [ccr 0x21] [cdr 0x86] [rcr 0xc000000] [pci irq
11] [lat 64/176] [bus 21/21]
ISA irqs (default) = 4,5,7,10,12 PCI status changes
cs: cb_alloc(bus 21): vendor 0x1317, device 0x1985
cs: cb_config(bus 21)
cs: IO port probe 0x0100-0x04ff: excluding 0x378-0x37f 0x3c0-0x3df 0x4d0-0x4d7
cs: IO port probe 0x0380-0x03bf: clean.
cs: IO port probe 0x03e0-0x04cf: clean.
cs: IO port probe 0x04d8-0x04ff: clean.
cs: IO port probe 0x0800-0x08ff: clean.
cs: IO port probe 0x0a00-0x0aff: clean.
cs: IO port probe 0x0c00-0x0cff: clean.
fn 0 bar 1: io 0x800-0x8ff
fn 0 bar 2: mem 0x60060000-0x600603ff
fn 0 rom: mem 0x60040000-0x6005ffff
irq 11
cs: cb_enable(bus 21)
bridge io map 0 (flags 0x21): 0x800-0x8ff
bridge mem map 0 (flags 0x1): 0x60040000-0x60060fff
tulip_attach(device 15:00.0)
tulip.c:v0.91g-ppc 7/16/99 [EMAIL PROTECTED] (modified by [EMAIL PROTECTED] for
XIRCOM CBE, fixed by Doug Ledford)
eth0: ADMtek Centaur-C rev 17 at 0x800, 00:10:7A:69:40:99, IRQ 11.
tau:~# lsmod
Module Size Used by Not tainted
tulip_cb 31872 2
cb_enabler 2528 2 [tulip_cb]
ds 6720 2 [cb_enabler]
i82365 22416 2
pcmcia_core 41408 0 [cb_enabler ds i82365]
usb-uhci 20996 0 (unused)
vfat 9276 2 (autoclean)
fat 29112 0 (autoclean) [vfat]
usbmouse 1792 0 (unused)
usbcore 51744 1 [usb-uhci usbmouse]
mousedev 3808 0
input 3264 0 [usbmouse mousedev]
maestro 26688 0 (unused)
soundcore 3492 2 [maestro]
rtc 5528 0 (autoclean)
tau:~# ifconfig
eth0 Link encap:Ethernet HWaddr 00:10:7A:69:40:99
inet addr:192.168.1.144 Bcast:192.168.1.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:18 errors:0 dropped:0 overruns:0 frame:0
TX packets:9 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:1865 (1.8 KiB) TX bytes:958 (958.0 b)
Interrupt:11 Base address:0x800
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:8 errors:0 dropped:0 overruns:0 frame:0
TX packets:8 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:560 (560.0 b) TX bytes:560 (560.0 b)
tau:~# ping 192.168.1.1
PING 192.168.1.1 (192.168.1.1): 56 data bytes
64 bytes from 192.168.1.1: icmp_seq=0 ttl=255 time=0.5 ms
64 bytes from 192.168.1.1: icmp_seq=1 ttl=255 time=0.3 ms
64 bytes from 192.168.1.1: icmp_seq=2 ttl=255 time=0.3 ms
--- 192.168.1.1 ping statistics ---
3 packets transmitted, 3 packets received, 0% packet loss
round-trip min/avg/max = 0.3/0.3/0.5 ms
tau:~# cat /proc/interrupts
CPU0
0: 23292 XT-PIC timer
1: 1163 XT-PIC keyboard
2: 0 XT-PIC cascade
8: 3 XT-PIC rtc
11: 58 XT-PIC ESS Maestro 2E, usb-uhci, i82365, eth0
12: 10 XT-PIC PS/2 Mouse
14: 3206 XT-PIC ide0
15: 4 XT-PIC ide1
NMI: 0
LOC: 0
ERR: 0
MIS: 0
tau:~# cat /proc/ioports
0000-001f : dma1
0020-003f : pic1
0040-005f : timer
0060-006f : keyboard
0070-007f : rtc
0080-008f : dma page reg
00a0-00bf : pic2
00c0-00df : dma2
00f0-00ff : fpu
0170-0177 : ide1
01f0-01f7 : ide0
02f8-02ff : Lucent Microelectronics 56k WinModem
02f8-02ff : serial(set)
0376-0376 : ide1
03c0-03df : vga+
03f6-03f6 : ide0
03f8-03ff : serial(set)
0800-08ff : cb_enabler
0cf8-0cff : PCI conf1
1c00-1cff : Lucent Microelectronics 56k WinModem
fb00-fb7f : 3Com Corporation 3c905C-TX [Fast Etherlink]
fc00-fcff : ESS Technology ES1978 Maestro 2E
fc00-fcff : ESS Maestro 2E
fe00-fe3f : Intel Corp. 82371AB PIIX4 ACPI
fe60-fe7f : Intel Corp. 82371AB PIIX4 ACPI
ff60-ff7f : Toshiba America Info Systems FIR Port Type-DO
ff80-ff9f : Intel Corp. 82371AB PIIX4 USB
ff80-ff9f : usb-uhci
fff0-ffff : Intel Corp. 82371AB PIIX4 IDE
fff0-fff7 : ide0
fff8-ffff : ide1
tau:~# cardctl ident 1
product info: "NETGEAR, Inc.", "FA511", "CardBus Mobile Adapter", "1.00"
manfid: 0x022d, 0x511a
function: 6 (network)
PCI id: 0x1317, 0x1985
Hope that helps.
Best regards,
--
Zane Dodson
[EMAIL PROTECTED]
