Hi, I'm using kernel 2.4.18, latest orinoco_cs driver (same as 2.4.19-pre8's, btw the driver comes with 2.4.18 does not work well at all), pcmcia-cs 3.1.33:
.... cs: IO port probe 0x0c00-0x0cff: clean. cs: IO port probe 0x0100-0x04ff: excluding 0x4d0-0x4d7 cs: IO port probe 0x0a00-0x0aff: clean. hermes.c: 5 Apr 2002 David Gibson <[EMAIL PROTECTED]> orinoco.c 0.11b (David Gibson <[EMAIL PROTECTED]> and others) orinoco_cs.c 0.11b (David Gibson <[EMAIL PROTECTED]> and others) eth1: Looks like an Intersil firmware version 1.03 eth1: Ad-hoc demo mode supported eth1: IEEE standard IBSS ad-hoc mode supported eth1: WEP supported, 104-bit key eth1: MAC address 00:55:5D:D6:AC:21 eth1: Station name "Prism I" eth1: ready eth1: index 0x01: Vcc 3.3, irq 3, io 0x0100-0x013f eth1: Error -110 setting multicast list. eth1: Error -110 setting multicast list. eth1: Error -110 setting multicast list. .... It works fine at low load (<100KB/s), however, if I wanna to dl/ul a big file (ie. 4 MB) from/to other local lan host, the link goes down and get this in the syslog (even worse, it could bring the whole wireless network down. When that happened, I had to reset the AP): eth1: error -110 reading Rx descriptor. Frame dropped. eth1: Error -110 writing Tx descriptor to BAP last message repeated 7253 times ============================================= I've also tried linux-wlan-ng-0.1.13 (or 0.1.14.pre?) and got same symptom. It reports the firmware version as: ident: nic h/w: id=0x800c 1.0.0 ident: pri f/w: id=0x15 1.0.5 ident: sta f/w: id=0x1f 1.3.4 ============================================= There is nothing wrong with the card, I've tested it on other's windows2000 machine and it handles quite well with big file downloading via the same AP. My questions is: I've found some posts against DWL650, same problem. Does anyone on this mailing-list use the same card without any problem at all? Thanks for reading, Jack -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
