Hi,
I'm not able to get USB to work so would appreciate some help. I'm using
2.2.19(not a custom build), 2.2r3 stable/proposed updates on a UMAX
533T. I'm trying to use a Belkin USB mouse for starters. Here what I did
so far. I used the procedures from the docs on linux-usb.org.
1. loaded the modules - usb-ohci didn't work so I assume the usb-uhci is
correct as supported in the boot message below
# lsmod (edited)
mousedev 3596 0 (unused)
hid 11384 0 (unused)
input 2684 0 [mousedev hid]
usb-uhci 18200 0 (unused)
usbcore 41028 0 [hid usb-uhci]
2. added the device files
$ ls -la /dev/input
total 0
crw------- 1 root root 13, 63 May 8 09:27 mice
crw------- 1 root root 13, 32 May 8 09:27 mouse0
Note the following.
# cat /dev/input/mouse0
cat: /dev/input/mouse0: No such device
3. added to /etc/fstab after /proc entry
none /proc/bus/usb usbdevfs defaults 0 0
$ ls /proc/bus/usb
001 devices drivers
Results from dmesg
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
usb-uhci.c: $Revision: 1.237 $ time 22:44:21 Apr 19 2001
usb-uhci.c: High bandwidth mode enabled
usb-uhci.c: USB UHCI at I/O 0xf300, IRQ 10
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 1
usb.c: USB new device connect, assigned device number 1
hub.c: USB hub found
hub.c: 2 ports detected
usb.c: registered new driver hid
mice: PS/2 mouse device common for all mice
usb.c: USB new device connect, assigned device number 2
usb_control/bulk_msg: timeout
usb.c: USB device not accepting new address (error=-110)
usb.c: USB new device connect, assigned device number -1
usb_control/bulk_msg: timeout
usb.c: USB device not accepting new address (error=-110)
usb.c: USB disconnect on device -1
$ cat /proc/bus/usb/drivers
hid
hub
usbdevfs
$ cat /proc/bus/usb/devices
T: Bus=01 Lev=00 Prnt=00 Port=00 Cnt=00 Dev#= 1 Spd=12 MxCh= 2
B: Alloc= 0/900 us ( 0%), #Int= 0, #Iso= 0
D: Ver= 1.00 Cls=09(hub ) Sub=00 Prot=00 MxPS= 8 #Cfgs= 1
P: Vendor=0000 ProdID=0000 Rev= 0.00
S: Product=USB UHCI Root Hub
S: SerialNumber=f300
C:* #Ifs= 1 Cfg#= 1 Atr=40 MxPwr= 0mA
I: If#= 0 Alt= 0 #EPs= 1 Cls=09(hub ) Sub=00 Prot=00 Driver=hub
E: Ad=81(I) Atr=03(Int.) MxPS= 8 Ivl=255ms
The only thing weird on the boot mesg is that I physically only have one
USB port but the system is trying to assign 2 devices.
Thanks in advance for any help.
Eric
