What is the output of "X -probeonly" ? What resolutions does it recognise ? Brendan Simon.
stephan wrote: > Ok - the XF86Setup error is this: > _X11TransSocketUNIXConnect - Can't connect error no 111 > > I get it when it Attempts to start the X server. > hope that helps a bit more > > stephan wrote: > > > I have just almost successfully installed X on my laptop. My last > > problem is this: > > I have a 1024x768 screen, yet I can only seem to get it to come up as > > 320x200. > > So basically there is a small window in the middle of my screen that > > displays X, > > and the graphics are rather large (it is running at 8bpp as opposed to > > 16). I'm really > > not sure where to go with this. I've tried xvidtune but that gets a > > floating point exception, > > xf86config gives me these results, and XF86Setup seems to do more damage > > than good > > (I'm sorry that isn't very specific, but I've just fought it four or > > five times in a row and I > > didn't right down the error message these last two times). I had X > > running fine with redhat > > and suse, so I know it is possible, I'm just not quite sure how. > > > > Sony vaio N505VE > > neomagic card > > SVGA server > > 1024x768 screen, should be at 16bpp > > > > Thanks for any help in advance - if more info is needed from me please > > let me know. > > > > Steve > > > > -- > > To UNSUBSCRIBE, email to [EMAIL PROTECTED] > > with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED] > > -- > To UNSUBSCRIBE, email to [EMAIL PROTECTED] > with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
