On Fri, 13 May 2005 22:00:20 +0200, plungeknob scareaunts wrote: > Hi everyone, > > I use DHCP to access the Internet at home, running Sid on my Toshiba. > Yesterday I downloaded netenv. Having little background knowledge on > networking and even less on modifying configuration files on Debian, I > was hoping to use my Debian in the office, which has a cable Lan > connection with a fixed IP address 141.20.107.100. The network is > Windows based. > > So this is what I enterned when the Netenv dialog box came up during > bootup: > > current IP-address: 141.20.107.100 > netmask of the current subnet: 255.255.254.0 > IP-address of the current network: 141.20.106.0 > Broadcast-address: 141.20.107.255 > Gateway address: 141.20.106.1 > IP-address of the current nameserver: 141.20.1.3 > > Everything, except for the network IP and the broadcast address , is > exactly what I'd enter when I'm on Windows. But I can't seem to get > connected to the Internet with the above on Debian. Or I was probably > connected already, only the browser kept telling me "servers not > found". > > Did I do something wrong? Do I need Samba or something like that? > > Thanks! > > Han > >
Hi- Have you tried it manually at first? Like try running all the linux commands to give yourself an IP address, the netmask, route etc? I know this sounds more difficult but you can see how things go and see command line output. I would do these commands as root or close to it: ifconfig eth0 141.20.107.100 netmask 255.255.254.0 route add default gw 141.20.106.1 now edit your /etc/resolv.conf and put in: nameserver 141.20.1.3 now try pinging something like www.yahoo.com or similar. no rebooting necessary... So did things work? If not, may want to ensure that the kernel is agreeing with the network card you are using and that it gets inserted into the running kernel. I don't know much about netenv all in all, so I cannot comment on its usefulness. I tend to create different schemes in my /etc/network/interfaces for a variety of places that I need network access like wired and wireless. Then I just do an "ifup eth1=work" or whatever and that wireless scheme comes up with either static or dhcp assignments. I have done both this way with wired and wireless. Works great for me. I would definitely try the command line approach first and see if things work and look for any problems. You may need to change eth0 above or not... It will definitely work better when you are at the place for the network settings :) -- Michael Perry | do or do not. There is no try. -Master Yoda [EMAIL PROTECTED] | http://www.lnxpowered.org -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
