Hi,
I'm a linux newbie, need advice on how to access my usb thumb drive and
external cd burner. Below are the informations from dmesg when i plug
in those peripherals. Do i need to manually execute the mount command
after the devices are inserted? If yes, can somebody tell me what
parameter to use for the mount command? I'm running Sarge, kernal 2.6.8
on Toshiba Satellite 2410
dmesg from my USB thumb drive:
==============================
usb 2-1: new full speed USB device using address 2
Initializing USB Mass Storage driver...
scsi0 : SCSI emulation for USB Mass Storage devices
Vendor: Kingston Model: DataTraveler 2.0 Rev: 4.70
Type: Direct-Access ANSI SCSI revision: 02
USB Mass Storage device found at 2
usbcore: registered new driver usb-storage
USB Mass Storage support registered.
SCSI device sda: 239872 512-byte hdwr sectors (123 MB)
sda: assuming Write Enabled
sda: assuming drive cache: write through
/dev/scsi/host0/bus0/target0/lun0: p1
Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0
dmesg from my external cd burner:
=================================
usb 2-1: new full speed USB device using address 3
scsi1 : SCSI emulation for USB Mass Storage devices
Vendor: ASUS Model: CRW-5224A Rev: 1.00
Type: CD-ROM ANSI SCSI revision: 02
sr0: scsi3-mmc drive: 52x/52x writer cd/rw xa/form2 cdda tray
Attached scsi CD-ROM sr0 at scsi1, channel 0, id 0, lun 0
USB Mass Storage device found at 3
Many thanks for the advices.
- Rony -
__________________________________
Do you Yahoo!?
The all-new My Yahoo! - Get yours free!
http://my.yahoo.com
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
