On Sun, May 23, 2004 at 05:33:39PM -0400, Shaun T. Erickson wrote: > Shaun T. Erickson wrote: --snip-- > Regarding this ... during boot up I see this: > > ... > ... > Running 0dns-down to make sure resolv.conf is ok...done. > Cleaning: /etc/network/ifstate > Starting hotplug system: > input > [failed] net > pci > ** can't synthesize pci hotplug events > [failed] usb > ** can't synthesize root hub events > done > Setting up IP spoofing protection: rp_filter. > ... > ... > > It then goes on to configure network interfaces, except there aren't any > yet ... and lastly, it starts the pcmcia service.
Ok. It's been a while since I've had any PCMCIA devices, so I can't be too much help here I'm afraid. But I can at least give you some ideas. For starters, what you might want to look into is modifying /etc/modules to have your generic PCMCIA and network card modules loaded at boot. Alternately, you could change the boot order for PCMCIA support so that it gets loaded BEFORE the network devices are configured. (This would be done by changing the rc symlinks.) You could try installing hotplug and see if it will handle your PCMCIA devices as well since I know that hotplug gets called before the network interfaces get configured. Finally, you can check if there's a way to have the PCMCIA support automatically configure your network interface for you. Some sort of scripts that automatically get run when PCMCIA detects a device perhaps? (This sounds more like a hotplug thing, but I'm not sure just where the hotplug/PCMCIA distinction lies.) Good luck. :) -- Alex Malinovich Support Free Software, delete your Windows partition TODAY! Encrypted mail preferred. You can get my public key from any of the pgp.net keyservers. Key ID: A6D24837 -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
