Hey,
I have tried to use the 0, and that didn't work. I 've visited this
web page http://www.mbsi.ca/cnxtlindrv/hsf/downloads.html and I've followed
the instructions to install the modem and i have used the X3 commands for AT
as specified (ATX3DT) but I allways find the same problem. When I run
hsfconfig --country, the countries listed doesn't offer me the choice to
specify mine: Andorra. Could that be the source of my problems as no carrier
and dialtone are detected?
I have even disabled APM support on the kernel (2.4.18) as I read
that someone took problems with that but it's no use. May I have to install
sound driver support on the kernel to make it right?
I will try to configure it with the kernel 2.4.20 but if someone has
any idea it'll be welcommed!
Jordi Cerdan
[EMAIL PROTECTED]
-----Mensaje original-----
De: mi [mailto:[EMAIL PROTECTED]
Enviado el: miércoles, 19 de marzo de 2003 14:44
Para: [EMAIL PROTECTED]
Asunto: Re: Modem on Fujitsu C1020
Hola Jordi Cerdan,
One possibility is that on your line you may have to predial a '0' ( like
with some isdn machines ). Then you can apply this to the dialnumber.
afaicr you can put several colons ',,,' after the '0' if a delay is needed.
> I have encountered some problems on configuring the modem under
> Debian Woody. I have installed the conexant HSF modem (it seems to be
> this one as the vendor ID and the Device ID are correct) but always i
> try to connect (I have configured the connection with pppconfig) the
> modem says there's no dialtone.
e.g. http://www.mbsi.ca/cnxtlindrv/hsf/downloads.html ?
...
> I live in Andorra. Could that be a problem for dialtone detection?
Hmm. Perhaps the modem doesn't understand catalan ?
--
micha.
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact
[EMAIL PROTECTED]
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
