Re: No network connection with a Xircom RealPort Cardbus Ethernet 10/ 100 + Modem 56 (RBEM56G-100)

[Ivar Alm]

At 18:02 2003-01-17, Irish, Jon D MEVATEC wrote:

I just installed Debian 3.0r1 on a Gateway Solo 2500 with a Xircom RealPort
Cardbus Ethernet 10/100 + Modem 56 (RBEM56G-100)card in it. During the
install, it failed to setup networking as it claimed there was no adapter
present. I finished the install from the CD and logged in as root. Running
dmesg, I see this:

tulip_attach (device 20:00.0)
tulip.c:v0.91g-ppc 7/16/99 [EMAIL PROTECTED] (modified by
danilo#cs.uni-magdeburg.de for XIRCOM CBE, fixed by Doug Ledford).
eth0: Xircom Cardbus Adapter (DEC 21143 compatible mode) rev 3 at 0x400,
00:10:A4:FB:53:D2, IRQ 10.
eth0: MII transceiver #0 config 3100 status 7809 advertising 01e1.

Then, lspci gives me this:

20:00.0 Ethernet controller: Xircom Cardbus Ethernet 10/100 (rev 03)

But ifconfig only shows a loopback adapter. Obiously, the system "sees" the
card, but it isn't be used. How can I fix this problem/

Have you tried 'ifconfig -a'? Shows all adaptersm including those down.
Are the modules loaded ok? What does 'lsmod' show?

You might have to specify your network properties (eg IP, NetMask etc) and start the interface with ifconfig. See the man page.

//Ivar
--
*********************************************************************
Ivar Alm ! Where does Microsoft want to drag you today? !
Umeå, Sweden ! Do you really want to go there? !
[EMAIL PROTECTED] ************************************************
http://www.octofingers.com


--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]