Hello there,
On my Compaq 1685 laptop, (running woody-stable)
since a couple of days, I am having
the following problem: when I put a CD in the drive's tray, either
a data or a music CD, the disc is not recognized, and I have the
following message in /var/log/messages:
Oct 20 23:02:28 joyce kernel: hdc: packet command error: status=0x51 {
DriveReady SeekComplete Error }
Oct 20 23:02:28 joyce kernel: hdc: packet command error: error=0x50
Oct 20 23:02:28 joyce kernel: ATAPI device hdc:
Oct 20 23:02:28 joyce kernel: Error: Illegal request -- (Sense
key=0x05)
Oct 20 23:02:28 joyce kernel: Command sequence error -- (asc=0x2c,
ascq=0x00)
Oct 20 23:02:28 joyce kernel: The failed "Pause/Resume" packet command
was:
Oct 20 23:02:28 joyce kernel: "4b 00 00 00 00 00 00 00 00 00 00 00 "
I am using a 2.4.19 kernel from the official tarball on kernel.org, and
use in addition pcmcia-cs 3.2.1 and alsa-* 0.9.0rc5. I am not using any
experimental features, and have enabled the ALI15X3 in the kernel
What I wonder is if this is a hardware failure, i.e. I'm screwed, or is
this some misconfiguration.
Here is the IDE output from the kernel:
Oct 27 23:01:35 joyce kernel: Uniform Multi-Platform E-IDE driver
Revision: 6.31
Oct 27 23:01:35 joyce kernel: ide: Assuming 33MHz system bus speed for
PIO modes; override with idebus
=xx
Oct 27 23:01:35 joyce kernel: ALI15X3: IDE controller on PCI bus 00 dev
80
Oct 27 23:01:35 joyce kernel: PCI: No IRQ known for interrupt pin A of
device 00:10.0.
Oct 27 23:01:35 joyce kernel: ALI15X3: chipset revision 32
Oct 27 23:01:35 joyce kernel: ALI15X3: not 100%% native mode: will probe
irqs later
Oct 27 23:01:35 joyce kernel: ide0: BM-DMA at 0xfc90-0xfc97, BIOS
settings: hda:DMA, hdb:pio
Oct 27 23:01:35 joyce kernel: ide1: BM-DMA at 0xfc98-0xfc9f, BIOS
settings: hdc:pio, hdd:pio
Oct 27 23:01:35 joyce kernel: hda: FUJITSU MHF2043AT, ATA DISK drive
Oct 27 23:01:35 joyce kernel: ide: Assuming 33MHz system bus speed for
PIO modes; override with idebus
=xx
Oct 27 23:01:35 joyce kernel: hdc: TOSHIBA CD-ROM XM-1902B, ATAPI
CD/DVD-ROM drive
Oct 27 23:01:35 joyce kernel: ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
Oct 27 23:01:35 joyce kernel: ide1 at 0x170-0x177,0x376 on irq 15
Oct 27 23:01:35 joyce kernel: hda: 8452080 sectors (4327 MB),
CHS=8944/15/63, (U)DMA
Oct 27 23:01:35 joyce kernel: hdc: ATAPI 24X CD-ROM drive, 128kB Cache
Oct 27 23:01:35 joyce kernel: Uniform CD-ROM driver Revision: 3.12
I have tried to use lspci to get any PCI information, but I only get:
pcilib: Cannot open /proc/bus/pci/02/00.0
lspci: Unable to read 64 bytes of configuration space.
Anxiously,
Michel Hardy-Vallée
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
